Publicité
Assembly
Observe the enclosed mounting sheet!
Connect the chain saw to the power supply system
only after having finished the complete assembly
Risk of injury!
Wear protective gloves when assembling.
Installing the guide bar and the saw chain
Place the chain saw on a level surface
and release the chain brake.
the front hand guard (13) against the
front handle (12).
Remove the cover (5) by removing the retaining nut (3).
Turn the chain stretching screw (4) anticlockwisely until the
chain stretching pin (6) is in its end position.
Insert the saw chain (2) into the circular guide slot of the
guide bar (1).
Attend to the correct running direction of the
chain links.
Put on the guide bar (1). The chain stretching pin (21)
must engage in the provided hole in the guide bar.
When assembling, pay attention that the chain
links are lying correctly within the guide slot
and on the chain wheel (8).
Remount the cover (5).
Clamping the saw chain as described in section
Clamping of saw chain
„
Before the first start-up
Chain lubrication (oil-automatic)
The chain saw is not delivered filled with saw chain
adhering oil
Never operate the chain saw without lubrication. Any use
without chain saw oil may result in damage of the saw
chain and guide bar.
The durability and cutting power of the chain depends on the
optimal lubrication. During operation the saw chain is
automatically wetted with oil.
Charging the oil tank
Schutzhandschuhe tragen!
Haut- und Augenkontakt vermeiden!
Put the chain saw on a suitable base.
Unscrew the oil tank lock (15).
Fill the oil tank with bio-degradable chain saw
adhering oil (app. 120 ml) (order no. 362928).
The fill level can be seen on the inspection window. For
easier filling use a funnel
When filling observe that no dirt reaches the oil
tank
Screw on the oil tank lock (15) again
Never use recycled oil or used oil. The guarantee expires
when using oil which is not allowed for such devices.
Press
.
"
Start-up
Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the saw to the
relevant and properly earthed plug.
Use a shockproof plug, mains voltage 230-240 V with
residual current circuit breaker (FI switch 30 mA).
Only use connection cables with sufficient diameters.
In case of disadvantageous power system conditions short-
term voltage reductions can occur during the starting process
of the device which can influence other devices (e.g. jittering
of a lamp). No failures are expected when the house service
connection has a continuous currect-carrying capacity
greater than 100 A per phase.
Fuse protection: 16 A time-lag
Mounting of the extension cable
In order to prevent an unintended loosening of the
connection assembly put the extension cable as noose through
the opening on the rear handhold and put it over the cable
mounting (19).
Switching On / Off
Make sure before each startup that the switch lock, the
On/Off switch and the chain and motor brake are working
properly
Do not use any device where the switch cannot be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Securely support the chain saw when switching it on and hold it
with both hands. Chain and guide bar must stand free.
Release the chain brake.
Push the front hand guard (13) towards
the front handle.
The chain saw is ready for operation.
Switching on
The device is equipped with a safety circuitry preventing
inadvertent switching on.
Push and hold trip switch (11). Than push the On/Off
switch (9). Now, you can release the trip switch.
Switching off
Release On/Off switch (9).
21
Publicité
