Publicité
More safety warnings
„Power tool use and care"
Switch off the device, wait until the saw chain has stopped
and remove the battery:
Contact of chain saw with soil, stones, nails or other
foreign substances
Check immediately chain and guide bar.
Carrying out repair work.
Performing maintenance and cleaning work.
Eliminating faults.
Transport.
Clamping again the chain.
Chain change.
Leaving of machine (also for short-term interruption).
Check the machine for possible damage:
Before further use of the machine the safety devices
must be checked carefully for their proper and intended
function. Only operate the machine with complete and
correctly attached safety equipment and do not alter
anything on the machine that could impair the safety.
Check whether movable parts function perfectly and do
not stick or whether parts are damaged. All parts must
be correctly installed and fulfil all conditions to ensure
perfect operation of the machine.
Damaged safety devices and parts must be properly
repaired or exchanged by a recognized, specialist
workshop; insofar as nothing else is stated in the
instructions for use.
Damaged or illegible safety labels have to be replaced.
Store unused devices in a dry, locked place.
Do not carry out repair operations on the machine
other than those described in section "Maintenance" but
contact the manufacturer or authorized customer service
centers.
Use only original spare. Accidents can arise for the
user through the use of other spare parts. The
manufacturer is not liable for any damage or injury
resulting from such action.
Refer to the enclosed brochure "General safety
instructions" for additional safety notices.
Vibrations
Hand arm vibration rear a
= 5.68 m/s²
h
Hand arm vibration front a
v
Measuring uncertainty 1.5 m/s²
The indicated vibration emission level has been measured
according to a standardised test method and can be used to
compare power tools.
It can also be used for an initial estimate of the vibration exposure.
The actual vibration emission level during the use of the
machine may differ from that indicated in the operating
instructions or indicated by the manufacturer.
This may be caused by the following factors to be minded before
and during the use:
20
= 4.69 m/s
2
Proper use of the machine
Correct cutting or machining of material
Proper condition of the machine for use
Use of the correct and sharp cutting tool
Handles and optional anti-vibration handles properly
mounted on the machine body
When you feel uncomfortable or notice discoloration of skin on
your hands during the use of the machine, stop working
immediately. Observe sufficient break times to rest. Failure to
have sufficient break times may result in a hand-arm vibration
syndrome.
The extent of exposure depending on the type of work or machine
use should be estimated and appropriate breaks taken. In this
way, the extent of exposure can be considerably reduced over the
entire work time. Minimise the risk caused by vibrations. Maintain
this machine according to the instructions in the manual. If you
intend to use this machine frequently, contact your local
authorised dealer and purchase anti-vibration accessories if
required. Avoid the use of this machine at temperatures under
10°C. Create a work schedule in order to minimise vibration
exposure.
Description of device / spare parts
Pos.
Denomination
1
Guide bar (sword)
2
Saw chain 91PJ 52X
3
Fastening nut
4
Chain stretching screw
5
Cover
6
Chain stretching pin
7
Seal Oil flow canal
8
Chain wheel
9
On/Off switch
10
Rear handle
11
Trip switch
12
Front handle
13
Front hand guard (chain brake)
14
Claw stopper
15
Oil tank cap
16
Guide bar cover (scabbard)
17
Safety label
18
Saw chain oil 100 ml (without pic.)
19
Cable strain relief
20
Installation wrench
Order-No.
364878
364686
391117
364879
364880
364881
364867
362923
364868
364865
362921
364869
362928
Publicité
