Publicité
The lifting device is not delivered with suction plates.
The customer is required to carry out a conformity assessment according to Article
12 of the Machinery Directive 2006/42 (see section 5.3).
The permissible upper and lower load limits are defined in Section 3 (Technical Data) and must be observed.
Also refer to the type plate or sticker for details of the maximum permissible load capacity.
You may not make any independent modifications or changes to the lifting device. It may only be operated
in the original condition as delivered.
WARNING
WARNING
Operator duties
The lifting device may only be installed and maintained by qualified specialist personnel and mechanics.
Qualified personnel is defined as: an employee who has received technical training and has the knowledge
and experience – including knowledge of corresponding regulations – necessary to enable him or her to
recognize possible dangers and implement the appropriate safety measures while performing tasks.
Qualified personnel must observe the relevant industry-specific rules and regulations.
12/44
There is a risk that the load may fall, crushing body parts or fatally
injuring people in the vicinity.
Independent modifications and changes compromise the lifting device's
required integrity. Its function may also be compromised.
►
Do not make any on-site modifications to the system.
Danger of death from falling if used as a means of transport for humans
or animals, or as a climbing aid.
This can result in broken bones, serious injury or even death.
►
Use of the lifting device as a climbing aid or to transport humans or
animals is prohibited.
Publicité
