Publicité
MN010575A01-AA
Chapter 5: Calls
5.2.1
Making Private Calls
Procedure:
1. To select a channel with an active subscriber ID, rotate the Channel Selector knob.
2. To call, press the PTT button.
3. Wait for the Talk Permit Tone to end, and speak into the microphone.
NOTE: If the selected channel is busy, a busy tone sounds. Your radio is unable to make a call.
4. To listen, release the PTT button.
If your radio does not detect voice activity for a predetermined period, the call ends.
5.2.2
Responding to Private Calls
When you receive Private Calls, your radio shows the following indications:
●
The green LED illuminates.
●
Your radio unmutes and the incoming call sounds through the speaker.
Procedure:
1. To respond, press the PTT button.
2. Wait for the Talk Permit Tone to end, and speak into the microphone.
3. To listen, release the PTT button.
If your radio does not detect voice activity for a predetermined period, the call ends.
5.3
All Calls
All Calls are one-way calls from an individual radio to all radios on a channel. All Calls are used for making
important announcements. The recipients on the channel cannot respond to All Calls.
When you receive All Calls, your radio shows the following indications:
●
The green LED illuminates.
●
Your radio unmutes and the incoming call sounds through the speaker.
All Calls do not wait for a predetermined period before ending. You can only continue with programmed
button functions after the All Call ends. If you switch to a different channel during an All Call, your radio stops
receiving the call.
5.3.1
Making All Calls
Procedure:
1. To select a channel with an all call ID, rotate the Channel Selector knob.
2. To call, press the PTT button.
3. Wait for the Talk Permit Tone to end, and speak into the microphone.
22
Publicité
