Publicité
upper lip of the DIN rail and one wide tab that snaps over the bottom lip
of the DIN rail. As shown in Figure 21, hold the Relay Driver at an
angle and gently slide the 3 upper hooks on the back of the Relay
Driver over the upper lip of the DIN rail.
Step 4
Once the hooks have engaged the upper lip of the DIN rail, rotate the
Relay Driver so that it is flush and parallel to the DIN rail as shown in
Figure 22.
Step 5
Hold the Relay Driver firmly in position while pushing the DIN rail tab
upwards. The tab will firmly snap when properly engaged with the DIN
rail.
CAUTION: Never attempt to remove the Relay Driver from the DIN
rail without releasing the DIN rail tab first. Damage to the Relay
Driver will result!
49 |
P a g e
M O R N I N G S T A R C O R P O R A T I O N
Publicité
