Publicité
should occur. The Turn On/Off delays specify how long to wait after a
threshold is met before turning on/off.
Choose the required parameters and click Finish.
The channel is now configured for GenStart. The Relay Driver Setup
screen should display the GenStart Function parameters in the
Configuration Summary for the channel.
If all four channels are configured as desired, refer to section 3.3 for
instructions on how to program the Relay Driver.
GenStart Advanced Setup Definitions
The following definitions can be used when configuring the Alarm/Fault
Function in Advanced setup. These values are assigned the
appropriate default values in Simple setup.
Control Address – the meter bus ID for the device that is to be
monitored. Factory default is one (1) for the TriStar and nine (9) for the
Relay Driver. (Not applicable in Standalone)
Maximum On Time – maximum generator run time
Minimum On Time – minimum required generator run-time before shut
down
Maximum Off Time – maximum period of time before forcing a run
cycle (maintenance cycle)
RELAY DRIVER
34 |
P a g e
Publicité
