Publicité
3.3 Programming the Relay Driver
When all four channels are configured as desired, the settings must be
programmed into the Relay Driver. The Relay Driver communicates
with a PC over a serial cable (included). Close all programs that may
be using the serial port. You will not be able to communicate with the
Relay Driver over the serial port if the it is already in use by another
program. This includes any programs or managers that run in the
background that detect hardware on the serial port.
Figure 15. An example Setup screen with channels configured
39 |
P a g e
M O R N I N G S T A R C O R P O R A T I O N
Publicité
