Publicité
Figure 6. Graph of Threshold timing delays
Control Address – the meter bus ID for the device that is to
be polled. Factory default is one (1) for the TriStar and nine (9)
for the Relay Driver. (Not applicable in Standalone)
Control Variable – choose from a list of variables associated
with the Control Type specified
High Threshold – upper value at which an event should occur
(See Figure 6)
Output State – output state when the Upper Threshold is
reached
Low to High Delay –time to wait after High Threshold is met
before changing state. If the Control Variable drops below
19 |
P a g e
M O R N I N G S T A R C O R P O R A T I O N
Publicité
