Morningstar RELAY DRIVER Manuel D'installation, D'utilisation Et D'entretien page 36

3.2.5 Meter Slave Function
Allow a Morningstar Device to control a Relay Driver channel directly.
(Future Use)
Common Applications:
Adding load control to Morningstar Devices

Adding Genstart control to Morningstar Devices

Setup
1. From the Relay Driver Setup screen, choose either Simple or
Advanced setup. (it does not matter which setup type is
chosen)
2. Select Meter Slave from the Function list.
Click Finish.
The channel is now configured for Meter Slave. The Relay Driver Setup
screen should display the Meter Slave Function parameters in the
Configuration Summary for the channel.
If all four channels are configured as desired, refer to section 3.3 for
instructions on how to program the Relay Driver.
RELAY DRIVER 36 | P a g e