Publicité
4.2 Wall Mounting
Figure 20. Relay Driver mounting hole dimensions
Step 1
Locate the Relay Driver on a surface that is protected from direct sun,
high temperatures, corrosive fumes, and water. Do not install in a
confined area where battery gases can accumulate.
Step 2
Before starting the installation, place the Relay Driver on the surface
where it will be mounted and determine where the wires will enter/exit.
Be sure there is sufficient bending room for the wires and
communication cables. If possible, verify that the mounting screws will
RELAY DRIVER
46 |
P a g e
Publicité
