not penetrate wires or other objects located on the opposite side of the
surface.
Step 3
Tape the included mounting template to the surface in the chosen
location. Place the Relay Driver on top of the template to confirm
correct positioning. With a drill and 1/8" bit, drill pilot holes for each of
the four mounting screws as indicated on the template. Remove the
template from the surface.
Step 4
Place the Relay Driver onto the surface and align the mounting feet
holes with the four pilot holes. Use the included #10 screws to secure
the Relay Driver to the surface.
47 |
P a g e
M O R N I N G S T A R C O R P O R A T I O N