Publicité
2. As vehicles travel through the capture zone, continue adjusting the camera until three successful
green scans are made until the Mobile Companion application sounds a chime.
Orange or red scans will not apply to the successful scan count.
3. When satisfied with the aiming results, hold the camera in place and use the Hex Key Tool to lock in
the position of the camera.
4. Remove the Mobile Phone Pouch and Mobile Phone.
5. Secure any power cables with the reusable zip ties and trim any carefully excess material from the zip
ties by performing one of the following actions:
●
If securing a Solar Panel deployment, secure the power cable above the camera.
●
If securing an AC or DC power deployment, secure the power cable as needed.
6. Optional: If necessary, replace and secure the Charging Port door with the Pin and Torx tool.
7. Tap Done.
Result: Installation is complete.
MN010089A01-AH
Chapter 3: Hardware Installation
63
Publicité
