Publicité
18. Perform one the following options:
Option
If the installer is at
the installation site and
ready to perform the
hardware installation,
If the installer is not at
the installation site,
2.9
Preparing for Travel
The product packaging or Quick Deployment Carry Case can be used to safely transport the camera and
accessories to the installation site. The Quick Deployment Carry Case is specifically designed to safely and
comfortably carry the L6Q Installation Kit up and down ladders.
Prerequisites: Ensure the Camera Batteries, or the Solar Panel Batteries, or both, are fully charged.
Procedure:
1. Disconnect any external power source from the camera.
2. Disconnect the External Antenna.
3. Replace the Charging Port Door:
a. Reinstall the door over the power bay.
b. Check that the door is flush with the camera housing to ensure that the camera is resistant to dust
and water ingress.
c. Tightly secure the security screw with the Pin and Torx Tool.
4. Pack the camera and accessories for safe travel to the installation site:
Option
If using the original product packaging,
Actions
Perform the following actions:
a. Disconnect any external power source from the camera.
b. Replace the Charging Port Door.
c. Check that the door is flush with the camera housing to ensure
that the camera is resistant to dust and water ingress.
d. Tightly secure the security screw with the Pin and Torx Tool.
e. Tap Continue Installation.
f.
Go to
Hardware Installation on page
Perform the following actions:
a. Tap Pause Installation → Back to dashboard.
b. Go to
Preparing for Travel on page
Actions
Perform the following actions:
a. Place the camera and accessories back in-
b. Close the packaging to secure the items.
c. Proceed to the camera installation site
Chapter 2: Pre-Installation
51.
49.
to the product packaging.
when ready.
MN010089A01-AH
49
Publicité
