Publicité
Option
If the camera is be-
ing mounted to a flat
surface,
2. Install the Camera Mounting Bracket:
a. Position the Camera Mounting Bracket in the direction of the flow of traffic.
b. Temporarily secure the top loops of the bracket with a Zip-Tie.
3. Secure the Metal Band Straps:
a. Loop the Metal Band Straps through the mounting loops to secure the bracket against the pole.
b. Fasten the straps with the Hex Key Tool.
4. Clean up the mounting bracket:
a. Remove the temporary Zip-Tie.
b. Trim the excess material from the Metal Band Straps.
3.6.2
Installing the Camera
Prerequisites: Ensure the following:
●
External power options are installed.
●
The Camera Mounting Bracket is installed.
●
The camera is paired to the Mobile Companion application.
●
The internal camera batteries are fully charged.
Obtain:
●
Long Range Antenna and Angle Adapter
●
Mobile Phone Pouch
●
Hex Key Tool
Procedure:
1. Select from one of the following options:
Option
If the Internal Battery On-
ly power option is being
used,
Actions
Install the Camera Mounting Bracket with two Lag Bolts:
a. Insert a drill bit into the Power Drill chuck.
b. Hold the bracket against the surface with the ball socket facing away
from the surface.
c. Adjust the bracket to its final mounting location and tap two mounting
holes through the lag bolt holes.
d. Equip the Power Drill chuck with a socket bit and Lag Bolt.
e. Screw the Lag Bolts through the bracket and into the surface.
f.
Tighten the Lag Bolts securely.
g. Proceed to
Installing the
Actions
Go to
step Step
3.
Chapter 3: Hardware Installation
Camera.
MN010089A01-AH
59
Publicité
