Instructions for use for the user
You can switch between the two modes as follows:
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
► The intensity display 4 displays either an intensity value or the temper-
ature, depending on the mode.
2. Press the bottom knob for three seconds (long press).
► The mode you just selected is shown in the top display:
Intensity regulation when the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set on a scale of 0 to 7. At 0, the additional device
is switched off. The value of 7 corresponds to full power.
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
2. Use the intensity selector 3 to set the preferred power of the additional
device.
3. Press the intensity selector 3.
► The additional device is switched on.
► The intensity selector 3 lights up.
Intensity regulation when the dimmer switch function is deactivated
When the dimmer switch function for the additional output has been deactivat-
ed, you can only switch the additional device on and off. The device will always
operate at full power.
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
► In the intensity display, "OFF" appears.
2. Press the intensity selector 3.
► The additional device is switched on.
► The intensity selector 3 lights up.
► In the intensity display, "ON" appears.
Room temperature control with the additional output
If the mode of the additional output is set to cabin temperature regulation, a sau-
na cabin temperature can be set, which is regulated using the additional output.
This can be used to regulate the cabin temperature using only infrared heaters
or infrared heating plates.
● Display: "StEP" - the additional output is in intensity
regulation mode.
● Display: "tE" - the additional output is in room temper-
ature regulation mode.
p. 35/48
EN