Publicité
Instructions for use for the user
6. Press the intensity selector 3.
► The vaporizer switches on.
► The intensity selector 3 lights up.
► Then the current humidity in the sauna cabin is displayed in the intensity
display 4. If a humidity temperature sensor is not installed, the preset
humidity is displayed.
The vaporizer (humidity function B) can only be started when the sauna
heater (temperature function A) is switched on. The maximum humidity
that can be set depends on the temperature of the sauna. The higher
the sauna temperature, the lower the maximum humidity level which
can be set.
Exception: Vaporizer single mode is activated (see "8.2. Settings in the
technician menu" on page 26). The vaporizer can also be operated
here without the sauna heater, with the maximum humidity depending
on the current sauna cabin temperature.
If the sauna control unit is used without a humidity/temperature sensor
(FTS2), cyclic mode is activated. If the sauna cabin temperature is less
than 30° C, the vaporizer is activated continuously for 10 minutes. This
ensures that the water in the tank reaches a basic temperature level.
Cycle mode then starts.
10.5. Starting additional output
Infrared heaters or infrared heating plates, for example, can be connected to the
additional output on the sauna control unit.
WARNING!
Risk of fire
Flammable objects that are placed on or in front of the infrared heater
could ignite and cause fires.
● NEVER place flammable objects on or in front of the infrared lamp.
● Make sure that NO flammable objects have been placed on or in front
of the infrared heater before you switch it on.
Two different modes are available for the additional output:
1. Intensity regulation
2. Room temperature regulation
p. 34/48
Publicité
