Télécharger Imprimer la page

JMA BERNA BIT Manuel D'utilisation page 8

Publicité

JMA
JMA
BERNA BIT
BERNA BIT
3. INSTALLATION AND PREPARATION OF THE MACHINE
3. INSTALLATION AND PREPARATION OF THE MACHINE
Installation of this machine presents no difficulty
whatsoever, but you should not attempt to install, adjust or
operate the machine without reading this user manual first.
The machine leaves our factory ready for use and only needs
to be calibrated for the tools that are going to be used.
3.1 ENVIRONMENTAL CONDITIONS IN THE WORKSHOP
- The machine should be used in places with an ambient
temperature of between 0º and 40º C, a relative humidity
of less than 50-60% and good lighting so that it can be
operated and maintained correctly.
1.
Use of the machine in explosive
atmospheres or in the presence of
flammable liquids or gases is strictly
prohibited.
3.2 CHARACTERISTICS OF THE LOCATION FOR
INSTALLATION
- Place the machine on a solid horizontal work surface
capable of properly supporting its weight (16 kg).
- The height of the work bench should be adapted to the
height of the operator. The machine should be at the same
height as the pelvis of the operator.
- We recommend leaving 30 cm of free space around the
machine for normal operation and maintenance.
1.
The voltage connected to the machine
should be the same as that connected
to the workshop and the workshop
should have an Earthing connection
and differential circuit breaker.
KEY CUTTING MACHINE
3.3 PREPARATION OF THE MACHINE
After positioning the machine on the work bench, the parts
that come packaged separately will need to be assembled
by the customer as follows:
- Put the two control levers in their corresponding locations.
- Connect the power cord to the electrical power supply.

Publicité

loading