Publicité
SAFETY MEASURES
2.2.4 General Safety Instructions
1.
Never disconnect the earthing
connection and make sure it is always
connected correctly.
- Always disconnect the power supply before carrying out
any maintenance or cleaning.
- Always disconnect the power supply when the machine is
not in use.
- Check cable conditions regularly. If they are worn or
damaged, replace them immediately.
- Keep all electrical connections safe from water and other
liquids.
- Do not pull violently on the electrical power cord.
- Ensure that the electrical power cord does not come into
contact with oils, sharp objects or heat.
- During the duplication stages, always keep your hands on
the carriage assembly motion controls.
- Always work with dry hands free of grease and oil.
- Do not use the machine in hazardous, damp or wet
locations.
- Everyone, and especially children, should keep a safe
distance to prevent contact with the machine and the
electrical cables.
2.3 RESIDUAL RISKS
The Berna Bit key cutting machine has been designed
with the utmost care to ensure it is safe during transport,
adjustment, duplication and maintenance. Nonetheless, it
is impossible to eliminate all risks, whether for technological
reasons or for issues related to use of the machine
(excessively complex operations).
Therefore, the following residual risks should be taken into
consideration when using the machine, as well as the risks
associated with its use:
1.
RISKS RELATED TO THE INSTALLATION
LOCATION
The location where the machine is installed
may present risks that could impact correct
operation of the machine (temperature,
humidity, rain, etc.).
2.
ELECTRICAL RISK
Given that the machine is fitted with
electrical devices, a risk of electrocution
exists if a fault were to occur. The electrical
power cord should be fitted with suitable
control and protection devices (thermal
magnetic circuit breaker and differential
circuit breaker).
3.
MECHANICAL RISK
The machine is fitted with tools (cutter
and tracer) that are necessary for key
duplication. The operator should therefore
be careful in order to prevent cutting their
hands when duplicating keys or replacing
the tools.
The operator should avoid wearing
necklaces, bracelets, rings and/or clothing
that could become trapped in the machine
or get caught up in the moving parts.
We recommend wearing a cap to cover
and contain your hair, especially for those
operators with long hair.
7 7
EN
Publicité
