Publicité
OPERATION
CLEANING AND CLEANING AGENTS
OPERATION WITH METRO CLEANING AGENTS
1.
Turn off the device before doing any setup or maintenance work.
2.
Check that the garden hose is also connected to the water inlet (29).
3.
Check if the high pressure hose (2) is connected to the manual spray gun
(23) and the water outlet (28).
4.
Insert the nozzle (3) for the cleaning product (black) into the spray lance.
5.
Then the engine starts.
Unsuitable cleaning agents can damage the appliance and the object to be cleaned.
•
Only use recommended cleaning products that are suitable for highpressure
cleaners available in DIY stores and car accessories, among others.
•
DO NOT use chlorine, bleach, trisodium phosphate, ammonia, acidic, caustic
or corrosive substances in the detergent system as the use of other cleaning
agents or chemicals may adversely affect the safety of the machine and could
damage the surface being used. is cleaning. Use only a car cleaning fluid or
mild detergent. The use of non-recommended substances in the detergent
system will void the product warranty. Using detergent requires the nozzle to
be used correct pressure (black).
•
Cleaning agents can be harmful to the environment.
To work with cleaning products, proceed as follows:
1.
Prepare the cleaning agent solution.
2.
Read the instructions for use of the nozzles.
3.
Check that the cleaning product nozzle (black) has been inserted.
4.
Open the filler cap on the detergent tank.
5.
Fill the detergent tank (15) with detergent. The "vacuum" created by
the flow of water through the pump allows detergent to enter the outlet
stream.
ATTENTION: Cleaning agent should not be applied with the high pressure nozzles
(white, green or red).
RECOMMENDED CLEANING METHOD
1.
Loosen dirt: Spray the cleaning agent sparingly and let it sit for 1
to 5 minutes, but do not let it dry.
2.
Remove dirt: Rinse loose dirt with a high-pressure jet.
3.
To interrupt operation, release the trigger (25) of the manual spray
gun (23).
4.
Turn off the engine when finishing the work (see 11.2).
5.
Turn off the water supply to the high-pressure cleaner.
6.
Pull the trigger (25) until the device is depressurized.
7.
Secure the manual spray gun (23) with the trigger lock (24) against
unintentional opening.
8.
Unscrew the water supply hose from the device.
NOTE: When you release the trigger (25) on the manual spray gun (23), the
engine continues to idle.
•
Turn off the engine during longer interruptions (several minutes)
•
Pull the trigger (25) until the device is depressurized. Secure
the manual spray gun (23) with the trigger lock (24) against
unintentional opening.
Do not leave the detergent in the detergent tank (15)!
After cleaning agent operation, clean the cleaning agent tank
(15) and the connected hoses.
76
EN - JET260X
Publicité
