Publicité
PARAMETERS FOR AVAILABLE
Para-
Function
meter
SENSOR FOR
F1.7
THERMOSTATIC
OPERATION
F1.8
THERMOSTAT
HYSTERESIS
AUXILIARY
F1.9
HEAT SOURCE
- DELAYED
ACTIVATION
F1.10 AUXILIARY
HEAT SOURCE -
STANDBY AT MIN.
TEMPERATURE
F1.11
DIFFERENTIAL
THERMOSTAT
F1.12 HEAT SOURCE
SENSOR
FOR DIFF.
THERMOSTAT
F1.13 HEAT SINK
SENSOR
FOR DIFF.
THERMOSTAT
F1.14 SWITCH- ON
DIFFERENCE FOR
DIFFERENTIAL
THERMOSTAT
* Depends on the controller model.
Service settings manual
OUTPUTS PROGRAMMING
Setting range
Selection of sensor for thermostatic
operation.
Hysteresis for thermostatic operation.
Selection if auxiliary heat source should
activate immediately or with delay if the
collectors have trend and tendency to
warm the water to requested temperature.
Delay time is considered as a time in
which the collectors should warm the
water to requested temperature. Auxiliary
heat source will activate immediately
if collectors don't have trend and
tendency to warm the water to requested
temperature in setted delayed activation
time.
Selection if auxiliary heat source should
permanently heat the water to min.
temperature.
Selection if programmed output should
operate as a differential thermostat.
Selection of heat source sensor (higher
temperature) for differential thermostat.
Selection of heat sink sensor (lower
temperature) for differential thermostat.
Switch -on difference setting for
differential thermostat.
Default value
Default
value
1- T1
2- T2
4*
3- T3
4- T4
5- T5
6- T6
1 ÷ 30 °C
4
0- NO DELAY
0
1 ÷ 1440 min-
DELAY
0- NO
0
1- YES, BY TIME
PR.
2- ALWAYS
0- NO
0
1- YES
2- YES,
INVERTED
1- T1
5- T5
3*
2- T2
6- T6
3- T3
4- T4
1- T1
5- T5
4*
2- T2
6- T6
3- T3
4- T4
4 ÷ 30 °C
8
|
EN
39
Publicité
