Publicité
BASIC PARAMETERS
SERVICE PARAMETERS
PARAMETERS FOR HEAT METERING
PARAMETERS FOR AVAILABLE OUTPUTS PROGRAMMING
FACTORY SETTINGS
* Depends on model of controller.
* The "n" symbol marks the successive number of d. h. w. storage tank or heat accumulator, if there is more than one d.
h. w. storage tank or heat accumulator present in the system. The "Tx" symbol marks the number of the sensor for which
the thermostatic operation of the available output is programmed.
User and settings manual
MENU STRUCTURE
AND DESCRIPTION
Differences and hysteresis
Minimum and maximum temperatures
Operation settings
Service parameters 1
Service parameters 2
Service parameters 3
Free programming of first third available relay output
operation.*
Reset of controller parameters.
Reset of time programs.
Reset of controller and restart of the first setting.
Save user settings.
Upload user settings.
EN
|
15
Publicité
