Publicité
PARAMETERS FOR AVAILABLE
EN
OUTPUTS PROGRAMMING
Group F contains the parameters for programming the available outputs.
The procedure for function parameters setting is the same as the procedure for service
settings.
TABLE WITH DESCRIPTION OF PARAMETERS
Para-
Function
meter
F1.1
OUTPUT
PROGRAMMING
F1.2
DEPENDENCE TO
OTHER OUTPUTS
F1.3
DEPENDENT
OUTPUT
F1.4
TIME PROGRAM
FOR OUTPUT
THERMOSTATIC
F1.5
OPERATION OF
OUTPUT
TYPE OF
F1.6
AUXILIARY HEAT
SOURCE
* Depends on the controller model.
|
38
Setting range
Selection of output for programming.
Define dependence of programmed output
to other controller's outputs.
&- selected relay has to be switched-on for
programmed output to be able to switch-
on
&!- selected relay has to be switched-off
for programmed output to be able to
switch- on
I- programmed output will switch-on
always when selected relay is switched-on
I!- programmed output will always switch-
on when the selected relay is switched-off
Selection of output on which depends
operation of programmed output.
Selection of required time program for
programmed output.
Selection if programmed output operates
as a thermostat.
Selection of type of heating source.
Default value
Default
value
0- NO
0*
1- R1
2- R2
0- NO
0
1- &
2- &!
3- I
4- I!
1- R1
*
2- R2
0- NO
0
1- P1
2- P2
3- P3
4- P4
5- SEL. PROG.
TIMER
0- NO
0
1- YES
2- YES,
INVERTED
3- YES, AUX.
SOURCE
4- YES, CASC.
SOURCE
1- BURNER
0
2- EL. HEATER
3- HEAT PUMP
Service settings manual
Publicité
