Publicité
CONTROLLER PARAMETERS AND
EN
AUXILIARY TOOLS
All additional settings and adjustments of controller performance are carried out by means of
parameters. In controller parameter settings menu there are three selectable groups:
Basic parameters
Service parameters
Heat metering parameters
Parameters for free programming available outputs
You can only see those parameters which have an effect on the selected hydraulic
scheme. Factory settings for parameters also depend on the selected hydraulic scheme.
BASIC PARAMETERS
Basic parameters are divided into groups P1, P2 and P3. In group P1 there are setting for
differences and hysteresis for built-in thermostats, in group P2 there are settings for minimum
and maximum temperatures for individual sensors, and controller performance settings in group
P3. When selecting the required parameter group in the menu, a new window opens:
Parameter mark
Diagram
of the setting
Parameter
description (Help)
You modify the setting by pressing the button
The value of setting starts to flash, and you can edit it by pressing buttons
. The setting is confirmed by pressing the button
and
You exit the parameter settings by pressing button
|
24
Current parameter value
to another parameter and repeat the procedure.
Current parameter
value
The last confirmed
setting value
Factory value
Setting range
.
. Now you can move by pressing buttons
.
and
Service settings manual
Publicité
