Publicité
Troubleshooting Guide
Problem
Aircraft will not
respond to throttle
but responds to
other controls
Aircraft will not
Bind (during
binding) to
transmitter
Aircraft will not
connect (after
binding) to
transmitter
Possible Cause
Throttle not at idle and/
or throttle trim too high
Throttle servo travel is
lower than 100%
Throttle channel is
reversed
Motor disconnected
from ESC
Transmitter too near
aircraft during binding
process
Aircraft or transmitter is
too close to large metal
object, wireless source or
another transmitter
The bind plug is not
installed correctly in the
bind port
Flight battery/transmitter
battery charge is too low
Bind button not held
long enough during
bind process
Transmitter too
near aircraft during
connecting process
Aircraft or transmitter is
too close to large metal
object, wireless source or
another transmitter
Bind plug left installed
in bind port
Aircraft bound to different
model memory.
Flight battery/Transmitter
battery charge is too low
Transmitter may have
been bound to a
different aircraft using
different DSM protocol
Solution
Reset controls with throttle
stick and throttle trim at lowest
setting
Make sure throttle servo travel
is 100% or greater
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Make sure motor is connected
to the ESC
Move powered transmitter a few
feet from aircraft, disconnect and
reconnect flight battery to aircraft
Move aircraft and transmitter
to another location and attempt
binding again
Install bind plug in bind port
and bind the aircraft to the
transmitter
Replace/recharge batteries
Power off and repeat bind
process.
Move powered transmitter a few
feet from aircraft, disconnect and
reconnect flight battery to aircraft
Move aircraft and transmitter
to another location and attempt
connecting again
Rebind transmitter to the
aircraft and remove the bind
plug before cycling power
Select correct model memory
on transmitter
Replace/recharge batteries
Rebind aircraft to transmitter
EN
19
Publicité
