Publicité
EN
Stop Lock Rate to 100% for all 3 axes. Then stick inputs can be used
to evaluate the current gain. This will ensure having full or closer to
full gain the moment the stick is released. Start with low gain and
work up. If the model continuously oscillates/bounces more than
once, then the AS3X+ gain is too high and needs to be reduced. One
or two bounces are acceptable. Once the gain is set the Stop Lock
Rate can be reset back to defaults to remove any small oscillations.
c. This may not be an issue on windy days as the turbulence should help
induce oscillations when the gain is too high.
4. If any axis other than roll starts experiencing oscillations as gain is
increased, pitch and yaw can be reduced in Gyro Settings > AS3X+
Settings > AS3X+ Gain.
5. If the gain channel is all the way up and no oscillations can be induced in
the model, increase the multiplier (Gyro Settings > AS3X+ Settings).
6. If the gain channel is barely increased and oscillations occur, decrease the
gain multiplier to provide a wider window of gain adjustment
(Gyro Settings > AS3X+ Settings ).
7. Once the desired gain is achieved, note the current value of the gain channel.
8. In the transmitter settings, change the gain channel assignment to a
switch, and then using the radios Digital Switch setup menu, adjust the
switch's channel outputs to -100% for gyro off, and then another position
to XX% (whatever value was noted in the previous step) for gyro on.
TIP: There are other methods of gain changes/disabling the gyro in flight.
See the Advanced Tuning AS3X+ sections of the
AS3X+ Setup Guide on the Spektrum Wiki page for
more advanced tuning information.
Scan the QR code to go to the Spektrum
Wiki page for advanced tuning options
SAFE Setup
Setting up SAFE
Programming.
1. Complete the AS3X+ setup and verify operation in flight.
2. Forward Programming Setup: To add SAFE flight stabilization the Flight
Modes on the receiver need to be configured.
a. In your transmitter's menu select
Forward Programming -> Gyro Settings -> First Time SAFE Setup
IMPORTANT: Before proceeding with setup, read every information
screen that will appear on your transmitter screen.
Select NEXT at the bottom of each page to continue.
b. Select FM Channel-> Select the channel and switch you want to use
for Flight Mode selection. You can select any channel that is not a control
surface, throttle or gain. Select Continue.
c. Position the model in a level flight attitude, then select Level Model
and Capture Attitude to teach the receiver the baseline setting. For
taildragger aircraft be sure to raise the tail so the fuselage is level.
10
technology on the AR637T+ receiver takes place in Forward
®
Publicité
