Publicité
EN
Troubleshooting Guide AS3X+
Problem
Oscillation
Inconsistent flight
performance
Incorrect
response to the
AS3X+ Control
Direction Test
18
Possible Cause
Damaged propeller or
spinner
Imbalanced propeller Balance the propeller
Motor vibration
Loose receiver
Loose aircraft controls
Worn parts
Irregular servo
movement
Gain too high
Travel or Rates
reduced causing
reduced servo
resolution
Trim changes after
initial setup
Changes to Sub-Trim
after initial setup
Aircraft was not
kept immobile for
5 seconds after
battery connection
Incorrect direction
settings in the
receiver, which can
cause a crash
Solution
Replace propeller or spinner
Replace parts or correctly align
propeller or other parts and tighten
fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts
(servo, arm, linkage, horn and
control surface)
Replace worn parts (especially
propeller, spinner, or servo)
Replace servo and/or servo
extension(s)
Reduce Gain
Move pushrod in on servo horn, or
move pushrod out on control horn,
and increase travel and/or rates.
Use the full servo travel to achieve
the desired throw.
If you adjust trim more than
8 clicks, select Relearn Servo
Settings in the Forward
Programming menu after landing
If you need to trim the aircraft
during test flights, select Relearn
Servo Settings in the Forward
Programming menu after landing
With the throttle stick in lowest
position. Disconnect battery, then
reconnect battery and keep the
aircraft still for 5 seconds.
DO NOT fly. Correct the direction
settings, then fly.
Publicité
