Maintenance - Mondolfo Ferro MT2450 Manuel D'utilisation

The wheel data are not correct.
➥ Check that the data corresponds to the dimensions of the wheel and correct, if
necessary.
➥ Carry out the sensor calibration procedure.
WARNING
The "Spare parts" manual does not authorise the user to work on the machine
except for the operations specifically described in the operator's manual, but is
intended to enable the user to supply accurate information to the technical service,
in order to reduce intervention times.
WARNING
The builder declines all liability for claims deriving from the use on non-original
spares or accessories.
WARNING
Before carrying out any adjustments or performing maintenance operations,
disconnect the electrical power supply from the machine and make sure that all
moving parts are suitably immobilized.
Do not remove or modify any parts of the machine except in the event of service
interventions.
ATTENTION
Keep the work area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible.
Keep the balancing machine shaft, the clamping ring-nut, the cones and the centring
flanges clean. Clean using a brush dipped in environmentally friendly solvents.
Handle cones and flanges with care to avoid the risk of dropping them and causing
damage that would affect centreing precision.
When not in use, store cones and flanges in a place where they are protected from
dust and dirt.
Use ethyl alcohol to clean the display panel.
Calibrate the machine at least once every six months.
88

MAINTENANCE

MT 2450 operator's manual