Wheel Spin; Using The Wheel Shaft Lock - Mondolfo Ferro MT2450 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Pressing the
imbalance values are displayed gram by gram (or in tenths of an ounce if the display in
ounces mode is active).
Pressing the same key again sets the two display modes in alternation.
Wheel spin takes place automatically when the guard is lowered, or can be triggered
by pressing the START key with the guard lowered.
A special safety device stops rotation if the guard is raised during the spin; in this case,
the "Err Cr" message appears.
During position search and when visual run-out check is activated, the wheel is able to
turn at low speed with the guard raised.
WARNING
Starting the machine without the guard and/or with the safety device incorrectly
positioned or tampered with is forbidden.
WARNING
Never raise the guard before the wheel has come to a stop.
WARNING
If, due to a fault on the machine, the wheel keeps spinning permanently, switch off
the machine at the master switch or unplug the plug from the power supply panel
(emergency stop). Then wait until the wheel stops before raising the guard.

USING THE WHEEL SHAFT LOCK

The wheel shaft lock is used to simplify fitting and removal of wheels using the relative
centring accessories, and during application of the balancing weights.
To activate the lock device, press the STOP button (the red one).
The wheel is released:
- by pressing the STOP button again;
- by performing a wheel spin;
- after 30 seconds.
Pressing the STOP button with the wheel in motion stops the wheel spin before
completion.
68
key eliminates the threshold (the light goes out) and the

WHEEL SPIN

MT 2450 operator's manual

Publicité

Table des Matières
loading

Table des Matières