General Characteristics - Mondolfo Ferro MT2450 Manuel D'utilisation

GENERAL CHARACTERISTICS

- Low balancing speed (80 rpm for truck wheels / 120 rpm for car wheels):
• minimises wheel spin times;
• reduces risks due to rotating parts;
• allows energy saving.
- Automatic sensor for measuring distance and diameter and for adhesive weights
application in Alu P=Easy Alu programmes.
- Automatic wheel stop at end of spin.
- STOP button which stops the machine immediately and locks the wheel shaft.
- Lift with safety handle which prevents tipping of the wheel and simplifies handling
operations
- Cover with trays to take weights of all types.
- Automatic start-up when guard is lowered.
- Luminous digital display unit double display and 3D graphics.
- Microprocessor data processing unit (16 bit).
- Resolution: 1 gr (0.1 oz) in car function
10 gr (0.5 oz) in truck function
- Wide selection of programs so that the machine is easy to use immediately.
- Imbalance display in grams and ounces.
- Imbalance display rounding setting.
- Types of balancing available:
• Standard
• Alu / Alu P= EASY ALU
• Static
- "Shift plane" program (in Alu P= EASY ALU mode) for use of weights in multiples of
five grams in car function and of 50gr in truck function (i.e. the weights available with
no need for intermediate sizes).
- "Hidden weight" program (in Alu P= EASY ALU) in order to sub-divide the outer
plane balancing adhesive weights into two equal weights positioned behind the rim
spokes.
- "OPT flash" program for rapid optimisation of operating noise reduction.
- "OPT standard" program (available on request).
- General utility programs:
• Calibration
• Servicing
• Self-diagnostics.
- Three separate working environments, allowing three different operators to work in
parallel with no need to set the data again.
- RPA, automatic wheel positioning in the position where the balancing weight has to
be applied.
- Visual check; this function allows visual verification of wheel and rim roundness
defects.
58
dynamic on both sides
seven different routines for aluminum rims
on a single side.
MT 2450 operator's manual