Other Messages; Using The Lift Carriage - Mondolfo Ferro MT2450 Manuel D'utilisation

Repeat acquisition process correctly.
Err 25
Program not available on this model.
Err 26 The "hidden weight" program has been activated outside the ALUP= EASY
ALU balancing function.
Select one of the Alu P= EASY ALU programs and then the hidden weight
program.
Err 27
Wheel not braked within the maximum permitted time. If the error recurs
frequently call in the technical after-sales service.
Err 28 Encoder count error. If the error recurs frequently, call in the technical
after-sales service.
Err 29 Failure on the wheel spin device. Try moving the wheel by hand; if the
fault does not disappear call in the technical after-sales service.
Err 30 During wheel spin the wheel has not started rotation within the maximum
permitted time. Repeat the spin; if the error persists call in the technical
after-sales service.
Err 31 Optimisation procedure (OPT) already launched by another user.
Err Stp
Wheel has stopped during spin.
Alu Err Dimension setting not correct for an ALU program.
Correct the dimensions set.
OPT Err Error conditoin during execution of the optimisation program.
Repeat the procedure from the beginning.
Err Cr Spin carried out with wheel guard up.
Lower the guard in order to carry out the spin.
CAL [GO] Calibration wheel spin.
GO Alu Wheel spin with Alu program selected.
St Wheel spin with Static program selected.
hid n
Setting of number of spokes in "hidden weight" program.
CCC CCC Imbalance values over 1990 grams for truck wheels and 999 grams for car
wheels.

USING THE LIFT CARRIAGE

For correct operation, the pneumatic circuit supply pressure must not be lower than 6
bar.
The wheel balancer lifter trolley makes it possible to lift the truck wheels with a weight
up to 200 kg if the pneumatic circuit is supplied with a pressure no lower than 6 bar.
For wheels with a maximum weight of 300 kg, the pneumatic circuit supply pressure
must not be lower than 10 bar.
This circuit has an input pressure regulator filter, which can be adjusted to a maximum
value of approx. 12 bar.
84

Other messages

MT 2450 operator's manual