INSTRUCTION MANUAL
Cleaning
Please use medical alcohol to clean the silicone touching the finger inside of SpO
a soft cloth dampened with 70% isopropyl alcohol. Also clean the being tested finger using
alcohol before and after each test. To clean your equipment, follow these rules:
1. Shut down the pulse oximeter and take the batteries out of the battery wharf.
2. Clean the display screen using a soft, clean cloth dampened with a glass cleaner.
3. Clean the exterior surface of the equipment using a soft cloth dampened with the cleaner.
4. Wipe off all the cleaning solution with a dry cloth after cleaning if necessary.
5. Dry your equipment in a ventilated, cool place.
Disinfecting
The applied parts touching the patients' body are required to be disinfected once after each
use. The recommended disinfectants include: ethanol 70%, isopropanol 70%, glutaraldehyde-
type 2% liquid disinfectants.
Disinfection may cause damage to the equipment and is therefore not recommended for this
pulse oximeter unless otherwise indicated in your hospital's servicing schedule. Clean the
pulse oximeter before disinfecting it.
Caution: Never use EtO or formaldehyde for disinfection.
8.3 Troubleshooting
Malfunction
SpO
or PR is
2
shown unstably
The Oximeter
cannot be powered
on
Indication lamps
are suddenly off
Others
Reason
1. Finger might not be plugged deep
enough.
2. Finger is trembling or patient's body is in
movement status.
1. Power of batteries might be inadequate
or not be there at all.
2. Batteries might be installed incorrectly.
3. The Oximeter might be damaged.
1. The product is automatically powered off
when no signal is detected longer than 8
seconds
2. Lower power
- 19 -
MD300K2
2
Resloution
1. Retry by plugging the finger.
2. Try not to move.
1. Please replace batteries
2. Please reinstall the batteries
3. Please contact with local
customer service centre.
1. Normal
2. Replace the batteries
Please contact with local
customer service centre.
probe with