ChoiceMMed MD300K2 Manuel D'instructions page 13

MD300K2
4.2 Measurement Screens
There are two display modes as shown in the following pictures.
Description of measurement screens:
1. Measuring: The pulse oximeter is in the status of measuring.
It shows "Finger out" when there is no finger inserted or no signal is detected.
It shows "Probe off" when the sensor/probe is not connected to the pulse oximeter.
2. SpO %: SpO area of display
2 2
It shows the oxygen saturation level of functional hemoglobin during normal measurement.
The color of the SpO
It shows two dashes throughout probe off and finger out conditions.
3. 100: SpO high alarm limit; 90: SpO
2
4. : Pulse bar
5. 100: PR high alarm limit; 060: PR low alarm limit.
6. PR: PR area of display
It shows the pulse rate in beats per minute during normal measurement.
The color of the PR value will become red when the PR is beyond the alarm limits.
It shows three dashes throughout probe off and finger out conditions.
7. ID: 001, the ID number of the current patient is 001.
8. 12:00: The current time.
9. PI%: Perfusion Index indicator display area.
Fig.4.3
value will become red when the SpO
2
low alarm limit.
2
Fig.4.4
2
- 10 -
PULSE OXIMETER
is beyond the alarm limits.