ChoiceMMed MD300K2 Manuel D'instructions page 12

INSTRUCTION MANUAL
4 TAKE A MEASUREMENT
4.1 Install the Probe
1. Before use, check the pulse oximeter for mechanical damage.
2. Insert the SpO
disconnected from the unit, a prompt "Probe Off" will be shown in the status bar in the top left
of the display screen.
Note:
• The probes that specified for this device conform to the ISO80601-2-61 standard.
• The connector is also applied to uploading data to MedView software for reviewing.
For detailed information, refer to the instruction manual of MedView software.
After finishing the time setting, plug your finger into the sensor as shown in the following
illustration.
Select the suitable sensor in terms of type and dimension.
probe into the probe socket (refer to Fig.4.1). If the SpO
2
Fig.4.2 Placement of the sensor
Fig.4.1
- 9 -
MD300K2
probe is
2