Corghi ProLine 124 Manuel D'utilisation page 106

Q
5G
O
- Fit the head guard (Fig. 5H) fasten with screws and
washers.
- Fit the pole guard (Fig. 5I) fasten with screws and
washers.
- Install the inflation pressure gauge box on the pole
(Fig. 5L).
- Tilting adjustment (Fig. 5M): the speed of the pole
tilting must be adjusted not higher than 0.71 rad/s. After
many tilting cycles over time, it may be necessary to
re-calibrate. Adjust valves A on the cylinder, by turning
them clockwise the speed decreases, while counter-
clockwise it increases.
- Refit the side cover N (Fig. 5A).
ProLine 124 - 221
- Remove the side cover N (Fig. 6A).
106
5H
6A
ProLine 124-221-321-324 Operator manual
A
P
5I
5L
A
5M
P
6B