Bronpi HYDROBOX Instructions D'installation, D'utilisation Et D'entretien page 64

It is also necessary to clean the chamber of the heat exchangers, as the soot that accumulates in them makes difficult the correct circulation
of the smoke. In order to access to these zones in the model Hydrobox, you can do it directly from the front, opening the external door of the
boiler. On the Hydrotex and Hydroconfort models, to access to these registers, you must remove the original chamber from the boiler where
the display is located. In all cases, perform the following operations:
- Remove the record covers by loosening the different screws.
- Clean the ash deposited in the records.
- Mount back the covers.
- Check the tightness of the records.
In the Hydrobox model, in addition to the previous records, there is another front register, which must be cleaned too.
On all models Hydrobox and Hydrotex, you must also clean the existing register in the bottom right of the
boiler, you have to remove the side chamber and then perform the following operations:
- Remove the record covers by loosening the different screws.
- Clean the ash deposited in the records.
- Mount back the covers.
- Check the tightness of the records.
In the Hydroconfort model with ash compactor, it is necessary to clean this area. In order to do
this, you can find two registers that are accessible by the right side of the boiler, disassembling
the chamber of that side. As in previous occasions, you must:
- Remove the record covers by loosening the different screws.
- Clean the ash deposited in the records.
- Mount back the covers.
- Check the tightness of the records.
11.8. SEASONAL STOPPAGES
If the boiler is not going to be used for a long time it is advisable to leave the fuel tank empty,
as well as the auger in order to avoid the fuel compacting or gaining moisture and expanding.
It is necessary to clean the boiler and the smoke duct by removing the ash and other residues,
close all doors of the equipment. It is recommended to clean the chimney at least once a year.
Meanwhile, check the seals because if they are not in good condition (they do not seal the door), they do not ensure the proper operation
of the boiler. For this reason, it would be necessary to change them. You can find this spare part in the same Bronpi distributor where you
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 63 HYDROBOX, HYDROTEX AND HYDROCONFORT