Publicité
Les langues disponibles
Les langues disponibles
9.6.2.2.
PUFFER TANK TEMPERATURE
This menu allows selecting the temperature in the puffer
tank. In case you do not want to use your boiler to produce
sanitary water you should skip this menu. You can select
between 40º and 55º C, that is to say the temperature you
want your boiler to reach. The selected value should be
confirmed with the key
before going out of the menu.
9.6.2.3.
SUMMER / WINTER MODE
This menu has two options: "Summer" and "Winter". In case
we chose the winter mode the boiler will be able to manage
heating and sanitary water. Sanitary water will have priority
and should be installed directly to the boiler. In case we
have only one heating circuit the boiler will work same way
but only with this circuit parameters. The use of this working
mode is recommended during the coolest periods.
In case we chose the summer mode it will work when
we install a system of sanitary water because the boiler
consider that in summer we do not need heating the house,
only sanitary water. If our installation do not have sanitary
water we recommend select the winter mode.
9.6.3.
MENU 3. REMOTE CONTROL
IMPORTANT NOTE. Your boiler does not have
any remote control, reason why, to ensure the
proper funtion of the boiler, it is important this
menu is disabled (OFF)
9.6.4.
MENU 4. MANUAL AUGER LOAD
In the case the boiler during running on is out of
combustible, alarm Er18 (low combustible) will appear
because your boiler has a capacitive sensor to detect the
level of combustible in the hopper. To deactivate this alarm
it is necessary to slid the padlock to the right and the boiler
will go to stopped mode.
To initiate a new start, it is necessary refill the combustible
hopper before we switch on again the boiler
your boiler will not show any alarm, but it will not allow you
to switch on.
However, when the boiler is stopped and cold and the door
closed it is possible to do a pre-load of pellets during a
maximum time of 600 seconds to load the auger To start
this load go to menu "manual load" and after pressing key
ON and confirm with key
, the auger will automatically
start moving; you will see how the smoke extractor will start
during the load as a security mode. To stop this load press
the line OFF and confirm with key
Do not forget before switching on the boiler proceed to totally empty the pellet burner to avoid a dangerous situation.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
40
Remote Control
Manual Auger Load
, other way
.
Puffer Thermostat
46
47
Summer - Winter
Summer
Winter
Remote Control
Manual
56
48
49
50
HYDROBOX, HYDROTEX AND HYDROCONFORT
55
OFF
Publicité
