Publicité
Les langues disponibles
Les langues disponibles
9.5.9.
SWITCH ON AGAIN THE BOILER
Once the boiler is switch off it will not be able to switch it on
again until some security time has elapsed and the boiler is
cool enough. If you try switch on the display will show the
message "Recover. Ign."
Once security time has passed the boiler will switch on
again starting a new lighting cycle.
9.5.10.
BOILER STOPPED
In the next picture you will see the message the display will
show when the boiler is stopped.
9.5.11.
BOILER IN ALARM
When the boiler is under alarm mode, in the display you will
see the alternation of the following screens showing.
To unlock the boiler, slide the padlock to the right and the
boiler will start the unlocking process, and then you will
be able again to proceed with the ignition of the boiler.
Note: There are alarms that require the intervention of the
Technical Assistance Service to be unblocked.
9.6.
END USER MENU 1
To access user menu1 it is necessary push only once the
key
in the display.
Next board describes briefly the structure of the user menu
1 in the boiler. The available options are specified.
To select between different menus we will have to push
each line and will access to different available submenus.
In order to modify the values, select the desired value by
sliding your finger and confirm the value with the key
. To exit from the menu it is necessary to push the key
and go to the main screen, or increase one menu level by
pushing the key
.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Menu
Combustion manage
Heating manage
Puffer tank thermostat Value between 40 y 55ºC
Remote control
Manual auger load
Tue 22 May 2018
Tue 22 May 2018
Error 10 - Maximum Water Pressure
Submenu 1
Power
1, 2,3, 4, 5 y A
Auger calibration
Value between -7 y +7
Fan calibration
Value between -7 y +7
Boiler thermostat
Value between 40 y 80ºC
Summer / Winter
Summer / Winter
On/Off
On/Off
54
RECOVER ING.
OFF
Blocking Error
Submenu 2
HYDROBOX, HYDROTEX AND HYDROCONFORT
Publicité
