Bronpi HYDROBOX Instructions D'installation, D'utilisation Et D'entretien page 54

9.5.3. WATER TEMPERATURE ADJUSTEMENT
This function is only available inside the user menu. Check
the chapter 9.6.2.1.
9.5.4. WORKING POWER ADJUSTEMENT
This function is only available inside the user menu. Check
the chapter 9.6.1.1.
9.5.5. ROOM TEMPERATURE REACHES THE
REQUESTED VALUE BU THE USER
When room temperature reaches the requested value by
the user, the boiler receives the order through an external
thermostat connected to the boiler and automatically start
the switch of process, and will switch on automatically
when room temperature in under the consigned
temperature. This depends on the thermostat hysteresis
installed in your house.
9.5.6. WATER THERMOSTAT REACHES THE REQUESTED VALUE BU THE USER
When the water temperature of the boiler reaches the requested value by the user, the boiler start mode "stand by", i.e. starts modulation
lowing the power to adequate to the selected temperature of the water and keep on working. In this case it is possible that your house do not
reach the temperature requested from the external thermostat because the water temperature value that you have fixed is low for your comfort
temperature. We recommend putting an enough temperature value (70-75º) to allow the boiler keep on working and reach your house comfort
temperature.
9.5.7. CLEANING THE BURNER
During the standard working of the boiler automatic
cleaning processes are appearing periodically. The
cleaning remains during a few seconds and it consists on
cleaning the rest of pellet in the burner, blowing (increasing
the exhaust fan speed) and therefore help the proper
function of the boiler. During this process the display will
show the following message:
In the Hydroconfort model, the burner has an automatic
ash cleaning system, in addition to blower burner cleaning.
The burner has a cleaning system that periodically sends
the ashes that are generated in the combustion to the
ashtray (Cleaning system patented by Bronpi Calefacción
S.L) which consists of rotating the base of the burner and
brush it.
9.5.8. BOILER SWITCH OFF
To switch off the boiler we have to push the key
and the smoke extractor works at maximum power. This process will not finish until the boiler has reached the proper cooled temperature.
Meanwhile you will see these messages in the display:
Tue 22 May 2018
EXTINGUISH
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Tue 22 May 2018
Tue 22 May 2018
during three seconds. Then the boiler start the end cleaning process where the auger stop
53
NORMAL
CLEANING ON
Tue 22 May 2018
OFF
HYDROBOX, HYDROTEX AND HYDROCONFORT