Bronpi HYDROBOX Instructions D'installation, D'utilisation Et D'entretien page 63

In the case of model Hydroconfort, as it has an automatic cleaning system, the burner cleaning must be carried out when it is observed that
the holes in the base are obstructed and do not allow the passage of the oxygen for a correct combustion.
11.2. CLEANING THE ASH PAN
The ash pan should be emptied when necessary. The boiler should not be operated without having
the ash pan in position. In the event of using olive stone as fuel, the amount of ashes will be higher
than those produced by pellet. In this case the ash pan cleaning should be done more frequently.
In the Hydroconfort model there is a capacity viewer, in case you notice that the level is very high, it is
necessary to proceed with the emptying of the ashes.
11.3. ASH PAN DOOR AND COMBUSTION CHAMBER DOOR SEALS
The seals ensure the boiler air tightness and, thus, a proper performance.
It is necessary to check them regularly; if they are worn-out or damaged they should be replaced immediately.
You can find ceramic cord and self-adhesive fibre at the same Bronpi distributor where you bought your boiler.
These operations should be done exclusively by an authorised technician.
11.4. CLEANING THE CHIMNEY
When the pellet is burnt slowly, it produces tar deposits and other organic vapours that combined with the
humidity to create soot (creosote). An excessive accumulation of soot may cause problems in the smoke outlet
and the flue may catch fire if not maintained..
The cleaning of the boiler chimney should only be made when the equipment is cold. A chimney sweep should
perform this task and, at the same time, examine the smoke duct (it is recommended to write down the dates
of every cleaning and keep a register of them).
11.5. CLEANING THE GLASS
IMPORTANT:
Clean the glass only when it is cold in order to avoid possible explosion. You can use specific products. You
can find Bronpi vitro ceramic-cleaning product in the same Bronpi distributor where you bought your stove (see
drawing D83).
BREAKAGE OF GLASSES. The glasses, as they are vitro ceramic, resist until 750ºC and they are not subject to thermal
shocks. The breakage can only be caused by mechanical shocks (crashes or violent closing of the door, etc). Therefore, its
replacement is not included in the warranty.
11.6. EXTERNAL CLEANING
Do not clean the external surface of the boiler with water or abrasive products because they may damage the stove. Use a feather duster or
a moist rag
11.7. CLEANING THE ASH RESERVOIRS
In order to keep the validity of the guarantee period, it is mandatory that the cleaning of the
records is carried out by a technician authorized by Bronpi Calefacción, who will leave a
written record of the intervention made.
It is about cleaning the ash records of the boiler as well as the area of passage of the fumes.
First of all, it is necessary to thoroughly clean the interior of the combustion chamber, descaling the soot
adhered to the walls, as this makes difficult the heat exchange and rub with a steel brush the surfaces with
accumulated dirt.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 62 HYDROBOX, HYDROTEX AND HYDROCONFORT