Publicité
Les langues disponibles
Les langues disponibles
11. Remove the drill holder
the rotatable drill mount
by 180°. Using the same adjustment, you
can grind the opposite cutting edge of the
drill.
12. Switch the device on and grind the drill.
13. Switch the device off and wait for the
grinding wheel
[
10 ]
Sharpening picks and chisels
[
C ]
1. Mount the selected sharpener (see
Mounting sharpener).
2. Place the blade on the tool table
it lies against the spacer
holder
keeps the blade in position.
[
5 ]
3. Release the retaining screw for the angular
adjustment
and turn the tool table
7 ]
[
into position. Select the angle according
to the existing bevel angle (angle of the
bevelled edge).
4. Tighten the retaining screw for angular
adjustment
again.
[
7 ]
5. Switch the device on and move the tool
table
equally back and forth along the
[
6 ]
grinding wheel
[
10 ]
6. Always use light pressure while sharpening
and slowly push the blade towards the
grinding wheel
[
10 ]
7. Repeat the sharpening process until all
irregularities have been removed.
8. Switch the device off and wait for the
grinding wheel
10 ]
[
NOTE
To sharpen a chisel, turn the chisel over
u
and repeat the process from Point 5.
Sharpening knives
D ]
[
and insert it into
14 ]
[
by rotating in
11 ]
[
to stop.
so that
6 ]
[
. The magnetic
[
4 ]
6 ]
[
.
.
to stop.
m
CAUTION!
Wear safety gloves when
handling knives and scissors.
NOTE
The device is not suitable for grinding
u
serrated knives.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Turn the machine on.
3. Insert the blade of the knife right into the
grinding slot.
4. Using light pressing guide the blade along
the grinding wheel
slowly pull the knife towards you.
5. Turn the knife and insert the knife blade into
the opposite grinding slot.
6. Repeat this grinding process for this side of
the blade as well.
7. Execute the alternating grinding process
until the cutting edge is burr-free and sharp.
8. Switch the device off and wait for the
grinding wheel
10 ]
[
Sharpening scissors
[
E ]
NOTE
The device is not suitable for grinding
u
serrated scissors. The device is not
suitable for grinding pinking shears.
1. Mount the selected sharpener for knives
and scissors
(see Mounting sharpener).
1 ]
[
2. Completely open the scissors.
3. Turn the machine on.
4. Insert one of the scissor blades into the
grinding slot.
5. Using light pressure guide the blade from
the screw up to the tip along the grinding
wheel
.
[
10 ]
and evenly and
10 ]
[
to stop.
GB/IE
31
Publicité
