Publicité
Les langues disponibles
Les langues disponibles
Maintain power tools and
accesssories. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect
the power tool's operation. If
damaged, have the power tool
repaired before use. Many accidents
are caused by poorly maintained power
tools.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less Iikely to bind and are
easier to control.
Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations different
from those intended could result in a
hazardous situation.
Keep handles and grasping
surfaces dry, clean and free from
oil and grease. Slippery handles
and grasping surfaces do not allow for
safe handling and control of the tool in
unexpected situations.
Service
Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the power
tool is maintained.
˜ Further Safety Instructions
Connect the device only to a power point
with a RCD (Residual Current Device) with
a measured residual current of not more
than 30 mA.
Keep the mains cable and extension cable
away from the grinding wheel. In the event
that it is damaged or severed, immediately
disconnect the plug from the socket.
28 GB/IE
Do not touch the cable before it has been
disconnected from the mains. Risk of electric
shock.
The replacement of the plug or the cable
must be carried out by the manufacturer or
his/her customer service in order to avoid
any hazards.
Only switch the device on once it is safely
fixed to the worktop.
For your own safety only use accessories
and attachments which were stated in the
operating instructions or recommended or
specified by the tool manufacturer.
Only use grinding wheels where the printed
rotational speed is at least as high as what
has been specified on the name plate of the
device.
Carry out a visual inspection of the grinding
wheel before use. Do not use any damaged
or deformed grinding wheels. Replace any
damaged or worn grinding wheels.
Make sure that the sparks produced
by grinding do not present a danger,
e.g. reach people or ignite flammable
substances.
Never keep the fingers between the
grinding wheel and spark protection or
in close proximity to the protective hoods.
There is a risk of crushing.
The rotating parts of the device cannot
be covered due to functional reasons.
Therefore, proceed cautiously and hold the
workpiece firmly in order to avoid slipping
which could cause your hands to come into
contact with the grinding belt or grinding
wheel.
The workpiece gets hot during grinding.
Do not touch the machined area, allow it
to cool down. There is a risk of burning. Do
not use coolants or the like.
If you are tired or have consumed alcohol
or tablets, do not work with the device.
Always have a break on time.
Switch the device off and remove the mains
plug
−
to loosen a blocked insertion tool,
Publicité
