Publicité
Les langues disponibles
Les langues disponibles
˜ Operation
m
CAUTION! RISK OF INJURY!
Always disconnect the plug from the
u
mains socket before working.
Use only grinding disks and accessories
u
recommended by the manufacturer. The
use of other insertion tools and other
accessories may cause risk of injury.
Never operate the device without the
u
visual protection disk.
Switch on the equipment only when it is
u
safely installed on the work surface.
m
CAUTION!
Despite spark protection,
always wear safety goggles
while working in order to
avoid eye injuries.
m
CAUTION!
We recommend wearing ear
protection to prevent damage to
hearing.
m
CAUTION!
Keep your hands away from the
u
grinding wheel and grinding belt
when the device is in operation.
Injury hazard.
Switching on and off
NOTE
Ensure that the mains voltage matches
u
the specifications on the rating plate.
Connect the equipment to the mains.
1. To switch on, press the "I" On switch and
the device starts up
2. To switch off, press the "0" off switch and
the device switches off
After switching on the device, wait until the
device has reached its max. speed. Only then
must you start with the grinding.
30 GB/IE
.
A ]
[
3 ]
[
.
A ]
[
3 ]
[
m
CAUTION!
The disk will continue to run after
u
the equipment is switched off.
There is a risk of injury.
Test run:
Before starting work and after each change of
grinding disk, carry out a test run of at least 60
seconds with no load. Switch off the equipment
immediately if the disk runs lumpy, substantial
vibrations occur, or abnormal noises are
generated.
Sharpening drills
B ]
[
Drills with a diameter of 3-10 mm can be
sharpened.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Remove the drill holder
sharpener.
3. Insert the drill into the drill holder
not attach the drill.
4. Insert the drill holder
adjusting device
[
15 ]
for drill-fastening
[
12 ]
5. Push the drill to the front into the V-nut up to
the metal stop. The cutting edges of the drill
must fit closely to the metal surfaces.
6. Using the knurled nut fasten the drill for
drill-fastening
.
[
12 ]
7. Remove the drill holder
into the rotatable drill mount
using the knurled nut for drill-fastening
8. Check the alignment of the drill. The cutting
edges of the drill must be touching the
grinding wheel
10 ]
[
9. Switch the device on and grind the drill by
moving the rotatable drill mount to and fro
in the direction of the arrow.
10. Switch the device off and wait for the
grinding wheel
10 ]
[
from the
14 ]
[
. Do
14 ]
[
upwards into the
[
14 ]
using the knurled nut
.
and insert this
[
14 ]
from below
11 ]
[
12 ]
[
.
to stop.
.
Publicité
