ULTIMATE SPEED ULGD 10 A1 Traduction Du Mode D'emploi D'origine page 8

has a safety circuit against sparking
and overheating. Keep these instruc-
tions in a safe place.
The supply program enables you to
change a vehicle battery without
interrupting the voltage supply.
Ensure you hand over all documen-
tation when passing the product on
to anyone else. Any use that differs
to the intended use as stated above
is prohibited and potentially danger-
ous. Damage or injury caused by
misuse or disregarding the above
warning is not covered by the war-
ranty or any liability on the part of
the manufacturer. The device is not
intended for commercial use and
should only be used indoors. Com-
mercial use will void the guarantee.
The product must only be started up
initially by people who have been
trained to do so.
Note:
The vehicle battery charger cannot
charge any electrical vehicles with
integrated rechargeable battery.
Note:
No jumpstart of 12 V or 24 V
batteries possible.
8
GB/IE/NI/CY/MT
z Package contents
1 Vehicle battery charger
1 Operating instructions
1 Connecting cable with clamps
1 Connecting cable with loops
z Equipment
To do this see Fig. A, B:
After unpacking the product, please
check that all of the package con-
tents are present and that the battery
charger is in perfect condition. Do
not use the device if it is defective.
Vehicle battery charger
1
24 V mode
24V
2
(Program 5, 6, 7, 8 and 10)
, 12 V mode
12V
3
(Program 1, 2, 3, 4 and 9)
,
1
Charging current 5 A
4
(in 12 V mode)
Charging current 2.5 A
(in 24 V mode)
,
2
Charging current 10 A
5
(in 12 V mode)
Charging current 5 A
(in 24 V mode)