Publicité
turn off the unit and have it replaced by a professionally qualified technician.
•
Should it be necessary to replace the power cord, this replacement operation must
only be performed by an authorized service centre or by the manufacturer.
•
The device needs to be supplied with water that is suitable for human consump-
tion and compliant with the regulations in force in the place of installation. The
installation engineer needs confirmation from the owner/manager of the system
that the water complies with the requirements and standards stated above.
•
For machines connected to the mains water supply, the minimum pressure must
be 2 bar and the maximum pressure for correct machine operation must not ex-
ceed 4 bar.
•
The operating temperature must be within the range of [+5, +30]°C.
•
At the end of installation, the device is switched on and taken to rated operating
conditions, leaving it in a state in which it is "ready for operation".
•
After reaching the "ready for operation" condition, the following dispensing oper-
ations are carried out:
•
100% of the coffee circuit through the coffee dispenser (for more than one dis-
penser, this is divided equally);
•
Open the steam outlet for 1 minute.
At the end of installation, it is good practice to draw up a report of the operations.
•
It is forbidden to leave the machine switched on without the presence and sur-
veillance of a qualified operator. Simonelli Group is not responsible for damages
caused by failure to comply with this prohibition.
•
When adding the coffee, the operator must never put his hands into the container.
•
Be extremely careful when using the steam nozzle. Never place your hands under
the nozzle and never touch it right after use.
•
Before cleaning the unit follow the instructions given in this manual carefully.
•
Once started the washing machine, do not interrupt, the detergent residue may
remain inside the delivery unit.
•
In case of breakdown or poor function, turn off the unit. Never tamper with the
unit. Contact only professionally qualified personnel. Only the manufacturer or
an authorized service center can make repairs and only using original spare parts.
Non compliance with the above can compromise machine safety.
•
In case of fire, disconnect power to the machine by turning off the main switch.
Its absolutely avoid to extinguish the fire with water while power to the machine
is on.
•
Before performing any sort of maintenance, the authorized technician must turn
off the unit and unplug it from the mains.
•
When the machine is left unattended for a long period, close the water inlet tap.
12
Publicité
