Greencut GWP200X Guide D'entretien page 75

TROUBLESHOOTING
PROBLEM-SOLUTION TABLE
THE TABLE INCLUDES SOME OF THE MOST COMMON PROBLEMS AND THEIR REMEDIES.
ENGINE WILL NOT START POSSIBLE CAUSE
Electric starting: check battery Battery discharged
Fuel valve OFF
Check control position Choke OPEN
Engine switch OFF
Out of fuel
Check fuel
Bad fuel
Spark plugs faulty, fouled, or
improperly gapped
Remove and inspect spark plugs
Spark plugs wet with fuel
(flooded engine)
Fuel filter clogged, carburetor
Take engine to an authorized servicing
malfunction, ignition malfunc-
dealer or refer to manual
tion, valve stuck, etc.
CORRECTION ENGINE LACKS POWER
Recharge battery Check air filter
Move lever to ON
Move lever to CLOSE unless
Check fuel
engine is warm
Turn engine switch to ON
Refuel
Take engine to an authorized servicing
Drain fuel tank and carburetor. dealer, or refer to manual
Refuel with fresh gasoline
Gap or replace spark plugs
Dry and reinstall spark plugs.
Start the engine with throttle
THE MOTOR PUMP DOES'NT PUMP
lever in FAST position
Replace or repair faulty com-
ponents as necessary
75
POSSIBLE CAUSE CORRECTION
Filter element(s) clogged Clean or replace filter element(s)
Out of fuel Refuel
Drain fuel tank and carburetor.
Bad fuel
Refuel with fresh gasoline
Fuel filter clogged, carburetor
Replace or repair faulty compo-
malfunction, ignition malfunc-
nents as necessary
tion, valve stuck, etc.
1. Check whether there is enough water.
2. Check whether the filter at the end of the input hose is clogged.
3. Check whether the hose clamp is tight.
4. Check whether the water hose is damaged.
5. Check whether the suction height required is too high.
6. If the water pump is still unable to pump water, please contact your
distributor for assistance.
EN - GWP200X