Fronius TransPocket 4000 CEL Instructions De Service page 77

(7) (2)
(5) (6)
(4)
TP 08 remote control
The welding voltage is applied to the welding sockets with a 3-second time lag. The TP
08 remote control is then supplied with the welding voltage and the indicator (5) lights up.
If the TP 08 remote control has been connected since the power source was last swit-
ched on, the current and arc-force dynamic can only be set on the TP 08 remote control.
To restore the current and arc-force dynamic setting option on the power source and
other system add-ons:
Disconnect TP 08
1
Switch the power source off and back on again
2
(1) Parameter selection button
For selecting the following welding parameters
-
Welding current (6)
-
Arc-force dynamic (7)
(2) The "+" button ... increases the selected parameter value
(3) The "-" button ... decreases the selected parameter value
IMPORTANT! Regardless of the service codes listed in the "Troubleshooting" section,
the following service codes may be displayed on the TP 08 remote control:
Service code: -oFF
Cause: Poor contact with the workpiece
Remedy Satte Verbindung zum Werkstück herstellen
Service code: -E62-
Cause: Overheating of TP 08 remote control
Remedy: TP 08 abkühlen lassen
While the power source or other system add-on displays a service code, the TP 08
remote control is deactivated.
Press the "Process" button to select
1
the MMA welding process
Secure the earthing clamp to the
2
workpiece and clamp the electrode
holder to the TP 08 remote control
(1) (3)
Place the TP 08 on the workpiece so
3
that a tight connection is created bet-
ween the workpiece and the two con-
tacts (4)
(4)
77