Tr 4000 Remote Control - Fronius TransPocket 4000 CEL Instructions De Service

TR 3000 remote control - view from the right
(7)
IMPORTANT! Parameters which can be adjusted on the remote control cannot be alte-
red on the power source. These parameters can only be altered on the remote control.
TR 4000 remote
control

TR 4000 remote control

(3)
(4)
- min - 150 A:
0 minimum welding current
10 welding current is 150 A
- 100 A - max:
0 welding current is 100 A
10 maximum welding current
(7)
(6)
Changeover switch for polarity reverser
For controlling the polarity reverser (option)
(+) Positive welding potential on the (+) current socket
(-) Negative welding potential on the (-) current socket
HotStart adjuster
Manual metal arc welding ... influences the welding current during the ignition
phase
0 no influence
10 100% increase in the welding current during the ignition phase
Arc-force dynamic adjuster
Manual metal arc welding ... for influencing the short-circuiting amperage at the
instant of droplet transfer
(6) Arc-force dynamic adjuster
Manual metal arc welding ... for
influencing the short-circuiting
amperage at the instant of droplet
transfer
0 soft, low-spatter arc
100 harder, more stable arc
(1) Parameter switchover button
For selecting and displaying the
welding voltage and welding cur-
(1)
(2) rent parameters on the digital dis-
play
(3)
When changing a parameter, the
(4)
parameter value appears briefly on
the digital display of the remote
control so that it can be verified.
(2) Welding current adjuster
For selecting the welding current
75