Tr 2000 Remote Control; Tr 3000 Remote Control - Fronius TransPocket 4000 CEL Instructions De Service

TR 2000 remote
control
Front and rear view of TP 4000 CEL / TP 5000 CEL
power source
Parameters which can be adjusted on the remote control cannot be altered on the power
source. These parameters can only be altered on the remote control.
TR 3000 remote
control
TR 3000 remote control - view from above
TR 3000 remote control - view from the left
(5)
74
(1)
(2)
(1) (2) (3)
(4) (5)
Welding current range selector switch
For selecting the welding current range that can be set using the welding current
adjuster (3)
(1) Welding current adjuster
For selecting the welding current
(2) Arc-force dynamic adjuster
For influencing the short-circuiting
amperage at the instant of droplet
transfer
0 soft, low-spatter arc
100 harder, more stable arc
(1) Welding current indicator
For indicating the welding current.
Before the start of welding, the
machine automatically displays a
standard value based on the pro-
grammed parameters. During wel-
ding, the actual value is displayed.
(2) HOLD indicator
Every time you reach the end of
welding, the actual value for the
welding current is stored and the
Hold indicator lights up.
(3) Welding current adjuster
For selecting the welding current
(4) Welding process selector switch
For selecting the welding process
- MMA welding
- MMA welding with Cel elec-
trode
- Special processes
- TIG welding with touchdown
ignition