Mission Critical Xantrex XanbusSCP Guide Du Propriétaire page 38

Using Cascading Parameters to Configure
All Devices at Once
Xanbus-enabled devices are configured one at a time. However,
because devices often have common settings, cascading
parameters can simplify and speed up system configuration.
When a parameter is "cascaded," a newly configured device
setting is applied to all devices of the same device type on a
common AC or DC connection.
For example, if cascading parameters are enabled and a Battery
Size (Ah) parameter is changed on the inverter/charger setup
menu, the same battery size setting is applied to other
inverter/chargers that share the same DC connection in the
system.
To enable or disable cascading parameters:
1. On the System Settings menu, with Cascading
highlighted, press Enter.
2. Use the up arrow or down arrow button to change the
current setting—Enabled or Disabled.
3. Press Enter to select the new setting.
When configuring the network-managed power system with
cascading parameters enabled, you should verify that the
configurations have been cascaded correctly to other devices.
Communication errors may cause parameters to revert to their
original values or generate a warning message on the SCP.
38
Viewing Device Information
The Device Info screen shows the model number, silicon chip
serial number and firmware revision for each Xanbus-enabled
device. You cannot select or change any information on this
screen.
To view device information:
1. On the System Settings menu, with View Device Info
highlighted, press Enter.
The Device Info screen appears.
System Settings
Invert
AC Charge
System Mode
[Enabled]
Cascading
2. Press the down arrow button to view information for each
Xanbus-enabled device on the system.
3. Press Exit to return to the System Settings menu.
Xanbus System Control Panel (SCP) Owner's Guide