Mission Critical Xantrex XanbusSCP Guide Du Propriétaire page 17

To connect Xanbus cables to the SCP:
1. Connect the Xanbus cable (or two Xanbus cables, if the
SCP is located between two Xanbus-enabled devices) to a
Xanbus network input in the SCP.
2. Route and connect the cable(s) to the nearest Xanbus-
enabled device(s).
3. For additional devices, continue connecting cable as
described above.
4. Ensure the factory-supplied male network terminators are
inserted into the empty inputs in the Xanbus-enabled
devices at the beginning and end of the network. When the
network is completely connected, there should be no empty
network inputs in any Xanbus-enabled device.
975-1171-01-01
Mounting the SCP
The SCP can be mounted four ways:
Flush mounted through an opening in a wall using the
n
mounting plate.
Surface mounted using the mounting bracket.
n
Flush mounted through an opening in a wall and secured
n
with four #6 screws.
Installed in the XW Pro inverter/charger front panel. For
n
instructions on this option, see the XW Pro Inverter/Charger
Installation Guide.
SHOCK HAZARD
Before making an opening in a wall or panel, ensure there is no
wiring or other obstruction within the wall.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
WARNING
17